Assessment of the chipping process of beech (Fagus sylvatica L.) wood: knives wear, chemical and microscopic analysis of wood

ABSTRACT

The objective of this work was to investigate the rate of knife wear during the beech wood chipping process and to evaluate the changes in the chemical and microscopic structure of wood. A knife coated with AlCrN was selected for the study. This coating creates an abrasion resistant layer on the knife and has a higher resistance to abrasive wear and, therefore, a longer life. After chipping, the degree of knife wear was assessed using a gravimetric method and 3D scanning analysis. Microstructural and surface characterisation revealed that cracking and abrasive wear were the main causes of tool blunting. The maximum removal of material on the cutting edge was 240 µm, the average weight loss of 0.58 g. In relation to wear, wood fragments remained on the cutting knife. Infrared spectroscopy of wood fragments showed changes in the chemical composition due to the high temperatures in the blade of the knife, and elemental analysis, the higher content of Al, Cr, and N elements in the wood fragments, probably due to the presence of particles from the coating of the knives. Microscopic analysis of the chips revealed the presence of metal particles from the knives on the structural wood elements.

KEYWORDS:

• Coated knife
• cutting edge
• chemical structure
• SEM analysis
• BSE detector

Disclosure statement

No potential conflict of interest was reported by the author(s).

Additional information

Funding

This work was supported by funding from the Slovak Scientific Grant Agency VEGA “Research of the cutting tools at the dendromass processing in agricultural and forestry production” [Contract no. VEGA 1/0609/20 (40%)]; and the Slovak Research and Development Agency [Contract no. APVV-21-0180 (40%) and no. APVV-22-0034 (20%)].