References
- ‘Special Quality die steel & heat treatment acceptance criteria for die casting dies’, Nord American Die Casting Association, Arlington Heights, IL, USA, 2008.
- ‘Advanced manufacturing development – DC2010: Die insert material and heat treatment performance requirements’, FORD Motor Company, Dearborn, MI, USA, 2005.
- ‘Die insert material and heat treating specification’, DC-9999, GM Powertrain Group, Fredericksburg, VA, USA, 2005.
- Olejnik J: ‘Vacuum furnaces with high pressure charge cooling’, Metallurgy, 3/2002.
- Korecki M: ‘Technical and technological properties of gas cooling in high pressure chamber’, IX Seminarium Nowoczesne trendy w obróbce cieplnej, Bukowy Dworek, 2005.
- Kowalewski J, Korecki M and Olejnik J: ‘Next generation HPQ vacuum furnace’, Heat Treat. Prog., 2008, 8.
- Korecki M, Olejnik J, Szczerba Z and Bazel M: ‘Single-chamber 25 bar HPGQ vacuum furnace with quenching efficiency comparable to oil’, Ind. Heat., 2009, 9, 73–77.
- Korecki M, Olejnik J, Szczerba Z, Bazel M and Atraszkiewicz R: ‘Piec próżniowy Seco/Warwick typ 25VPT z hartowaniem w azocie i helu pod ciśnieniem 25 bar i jego nowe możliwości technologiczne’, XIII Seminarium Nowoczesne trendy w obróbce cieplnej’, Bukowy Dworek, 2010.
- Korecki M, Kula P and Olejnik J: ‘New capabilities in HPGQ vacuum furnaces’, Ind. Heat., 2011, 3.
- Dobrzański LA, Madejski J, Malina W and Sitek W: ‘The prototype of an expert system for the selection of high-speed steels for cutting tools’, J. Mate. Process. Technol., 1996, 56, (1–4), 873–881.
- Dobrzański LA and Trzaska J: ‘Application of neural network for the prediction of continous cooling transformation diagrams’, Comput. Mater. Sci., 2004, 30, (3–4), 251–259.
- Kula P, Atraszkiewicz R and Wołowiec E: ‘Modern gas quenching chambers supported by SimVac Plus hardness application’, AMT Heat Treatment, Detroit, MI, USA, 2007.
- Kula P, Korecki M, Pietrasik R, Stańczyk-Wołowiec E, Dybowski K, Kołodziejczyk Ł, Atraszkiewicz R and Krasowski M: ‘FineCarb – the flexible system for low-pressure carburizing’, ‘New options and performance’, Jpn Soc. Heat Treat., 2009, 49, 133–136.
- Sitek W: ‘Methodology of high-speed steels design using the artificial intelligence tools’, J. Achiev. Mater. Manuf. Eng., 2010, 39, (2), 115–160.
- Wołowiec E, Małdziński L and Korecki M: ‘Nowe inteligentne programy wspierające produkty Seco/Warwick’, XIV Seminarium Nowoczesne trendy w obróbce cieplnej, Bukowy Dworek, 2011, 71–80.