A new approach based on a concurrent cooling method during GTAW and DC-LSND welding to mitigate residual stresses in Al 6061-T6

Abstract

Welding often induces residual stresses and undesired distortion in components. The negative impacts of these detrimental residual stresses have prompted researchers to explore methods for preventing or mitigating these stresses. Altering the temperature history can influence residual stress, and employing cold or heating techniques during welding has the potential to reduce harmful residual stress. In this study, the dynamically controlled low-stress no-distortion (DC-LSND) method with TIG welding was utilized to reduce the residual stresses in Al alloy 6061-T6. The methodology was simulated using Abaqus software, and the simulation results were validated with experimental data. The Al alloy served as the base metal, alloy (ER-4043) as the filler, and dry ice as the coolant. In the finite element analysis, the longitudinal residual stress at the center of the weld line in TIG welding was calculated to be 77 MPa. In the DC-LSND welding method, this value approached zero. Experimental measurements revealed residual stresses in the center of the welding line to be 183 MPa in conventional welding and 130 MPa in DC-LSND welding. According to the DC-LSND results, a 100% reduction in residual stresses was achieved in the finite element method. In the experimental test, a reduction of approximately 30% in residual stress was observed. The method developed in this research is recommended for application in welding metals and alloys where phase changes do not occur.

Keywords:

• Al 6061-T6
• DC-LSND method
• TIG welding
• residual stress
• Abaqus software

Author contributions

Hamed Hemmatpour: conceptualization, methodology, data curation, writing – original draft, review and editing. M. A. Mohtadi-Bonab: data curation, supervision, review and editing, writing – original draft, review and editing.

Disclosure statement

No potential conflict of interest was reported by the author(s).

Data availability statement

Data will be made available on request.

Additional information

Funding

The authors acknowledge the support of Amirkabir University of Technology and University of Bonab.