References
- American Association of State Highway and Transportation Officials (AASHTO), 2012. Bulk specific gravity (Gmb) of compacted hot mix asphalt (HMA) using saturated surface-dry specimens (Standard No. T 166-12). Washington, D.C.: AASHTO.
- ASTM C1701-17, 2017. Standard test method for infiltration rate of In-place pervious concrete. West Conshohocken, PA: ASTM International.
- ASTM D6931-17, 2017. Standard test method for indirect tensile (IDT) strength of asphalt mixtures. West Conshohocken, PA: ASTM International.
- ASTM D7369-11, 2017. Standard test method for determining the resilient modulus of bituminous mixtures by indirect tension test (withdrawn 2020). West Conshohocken, PA: ASTM International.
- Datta, T.K., Gates, T.J., and Savolainen, P.T., 2012. Impact of Non-Freeway Rumble Strips Phase 1. (No. RC-1575) Wayne State University. Transportation Research Group, Wayne State University. Dept. of Civil and Environmental Engineering.
- Donnell, E.T., et al., 2014. Rumble Strips Installation on Thin Pavement Overlays (Final Report No. FHWA-PA-2014-007-PSU WO 7;LTI-2015-04). Thomas D. Larson. Pennsylvania Transportation Institute, Pennsylvania State University.
- FHWA, 2011. Center Line Rumble Strips (Technical Advisory No. T 5040.40, Revision 1). Federal Highway Administration.
- FHWA, 2011. Center Line Rumble Strips (Technical Advisory No. T 5040.40, Revision Federal Highway Administration.
- FHWA, 2015. Rumble Strip Implementation Guide: Addressing Pavement Issues on Two-Lane Roads (No. FHWA-SA-15-034). Federal Highway Administration.
- Guin, A., et al., 2014. Centerline Rumble Strips Safety and Maintenance Impacts (No. FHWA-GA-14-1212) Georgia Tech Research Corporation.
- Hawkins, N., et al., 2016. Rumble Stripe: Evaluation of Retroreflectivity and Installation Practices (Final Report No. MN/RC 2016-13). Institute for Transportation Iowa State University, Minnesota Department of Transportation.
- Haynes, M., Coleri, E., and Sreedhar, S., 2019. Impermeable asphalt concrete layer to protect and seal concrete bridge decks. Transportation Research Record: Journal of the Transportation Research Board, 2673, 355. doi:10.1177/0361198119841041.
- Himes, S., et al., 2017. State of the Practice for Shoulder and Center Line Rumble Strip Implementation on Non-Freeway Facilities (Draft Report No. FHWA-HRT-17-026). Federal Highway Administration.
- Howard, I.L., Alvarado, A., and Floyd, W.C., 2013. Performance Oriented Guidance for Mississippi Chip Seals - Volume II. (No. FHWA/MS-DOT-RD-13-211-Volume II) Mississippi State University. Dept. of Civil and Environmental Engineering.
- Kalathas, P., Parrish, C., and Zhang, Y., 2019. Rumble Strip Design Evaluation Based on Exterior Noise Using Finite Element Analysis (Final Report No. OR-RD-19-10). Oregon Department of Transportation.
- Kim, Y.-R., You, T., and Rilett, L., 2017. Design and Evaluation of Modified Centerline Rumble Strips (No. SPR-P1(16) M034). Nebraska Transportation Center.
- Liu, J., 2017. SDI-12 USB adapter user manual. Saint Cloud, MN: Tekbox Digital Solutions.
- ODOT, 2021. Oregon standard specifications for construction. Salem Oregon: Oregon Department of Transportation.
- Smadi, O., and Hawkins, N., 2016. NCHRP synthesis 490: practice of rumble strips and rumble stripes. Washington, DC.: Transportation Research Board.
- Torbic, D. J., et al., 2009. Guidance for The design and application of shoulder and centerline rumble strips. Washington D.C.: Transportation Research Board.
- Tufuor, E., Rilett, L., and LeFrois, C., 2017. In-Vehicle Evaluation of Milled Rumble Strips at Pre- and Post-Chip Sealed Maintenance Periods (No. SPR-P1(15)M037). Nebraska Transportation Center, Nebraska Department of Roads.
- Watson, M., et al., 2008. Long Term Maintenance Effects on HMA Pavements Caused by Rumble Strips and Available Preventive Treatment Methods (No. MN/RC 2008-50). Minnesota Department of Transportation.